Latest Articles

04 Dec

How does a novice farmer test the quality of a chicken cage?

With the development of the breeding industry, more and more farmers have begun to develop poultry breeding business. However, for new farmers, the chicken cage is a very unfamiliar device. I don't know how to distinguish between good and bad. Next, the author tells the farmers how to check the quality of chicken cages. [The detection method for broiler cages and battery laying hen cages is the same]

1. Solder joint tensile test: Farmers can randomly take a few points from the manufacturer ’s cage pieces and use the equipment to test the tensile strength to see how the manufacturer ’s cage equipment pulls. The growth and comfort of the flocks in the cages should be paid special attention by farmers.

2. The second method is that the farmers can extend the wire around the chicken cage nets to test. In the semi-finished chicken cages of the manufacturer, randomly select 3 nets, and then measure the protrusion value around the nets with a ruler.

3. Determination of the thickness of the galvanized layer of the chicken battery cage: When the farmers choose the equipment for the chicken cage, the galvanizing process must be done by each manufacturer to produce the chicken cage. In order to strengthen the corrosion-resistant and wear-resistant methods of chicken cage equipment, the thickness of the galvanized layer is more important. Farmers can randomly select and produce 3 bottom nets and 3 pairs of cages in the cage equipment of the poultry farming equipment manufacturer. Each piece can measure 3-5 points, and the lower point test data shall prevail.

4. Determination of the amount of deformation resistance: Because there are many chickens in each group of chicken cage farmers, the deformation capacity of the chicken cage equipment is related to the service life of the chicken cage equipment. Farmers can install several groups of cages. Adjust to a better state, and then measure each group of chicken cages three times. During each measurement, a heavy object (such as a brick) should be evenly placed on the bottom net instead of the weight of the chicken. The deformation amount is measured every five days, and a total of 3 measurements are performed. After 15 days, the load is removed to measure the deformation amount of the bottom mesh.

Subscribe to this RSS feed